Page 1 of 1
Hello from California
Posted: Mon Feb 16, 2026 6:35 pm
by leo.ti99037
My name is Leo and I have a Tie Fighter Pilot costume. I have been 3D printing some helmets and armor. I have always wanted to make a Snow Trooper costume. The bucket and armor is easy enough to print but I was wondering what the duster and cowl are made of. Not sure what KISS laminate is? I joined so I can find some material suggestions and patterns.
Re: Hello from California
Posted: Wed Feb 18, 2026 3:27 pm
by MaximumFirePower
KISS laminate is hard to get in the US but it was used for the cowls in ESB. I know some troopers use marine vinyl instead.
I found this RFP article on the topic helpful.
https://www.therpf.com/forums/threads/s ... uk.337079/
I ended get purchasing here
https://www.fabricuk.com/fabrics/998-ki ... rdant.html They only shipped to UK. So I had it shipped to a friend in the UK and then they shipped to me.
Re: Hello from California
Posted: Tue May 12, 2026 2:07 pm
by Captain_Wordo
Hi Leo and welcome to the Blizzard Force detachment!
Good luck with your build
