Blizzard Force

Hi

I am Dan from Japan, i was lucky enough to get a Dan laws Snowtrooper.

I replaced the helmet with a new Dan laws and the middle abdomon part as the other one was cracked.









I am currently building a 3D printed Webcannon , E11 ESB with greeblies and DLT20A.
looking forward to releasing 3D files etc once all modelled.

Regards,

Dan

Hi Dan and welcome to the Blizzard Force detachment!

Is your snowtrooper already approved? If so, don't forget to ask for deployment at this place: viewforum.php?f=12

Have fun and stay frosty

Hi Captain Wordo!

Many thanks for your reply and welcome!

I am not approved yet.

I want to change my belt
Change Holster
make E11 blaster 3d model greeblies will use a doopy doo doo spare kit,I may make a ally one as i have access to a factory punch and press
Redo my DLT19
3d print DLT20a
3d print hoth binos

Later make E Web 3d printed.

I hope to be approved by the 15th november for a troop

oh and lose weight and redo my gloves

You're welcome!

Sounds like you are quite busy, good luck with your adjustments

p4ntb0y wrote: ↑Mon Oct 19, 2020 10:46 pm oh and lose weight and redo my gloves

Haha, the toughest "trimming" in the whole build! Go get em!