Blizzard Force

I've just had my snowy approved by the Canadian Garrison and requesting Blizzard Force Deployment please.

Positive criticism would also be greatly appreciated.

Thanks

Good start but it looks like you are still missing a few things. You need the button for the ab plate. You're missing a paint detail around the right side bumps. Let's see some pics of the backpack and canister too.

Along with what Ian's said, you also mis-cut your eyes too large. You're going to need to either resculpt the detail back on or replace the face plate entirely.

Here are the new mods
Painted bump on chest armor.
Plastic and bondo and paint to shrink the eyes.
Button for the ab plate, one layer added, in the orginal pic the 3 dot were there.

Let me know if i am ready for Blizzard Force Deployment.

Ian and Jack, thanks for the feedback this is greatly appreciated.

Front


Back

dont feel bad I have learned that cutting out the eyes all the way is a common opps.
I will send you a pm for someone that can help with the face plate.

Thanks for the PM yoda, but i don't think i will need a new face place. I will if BF instructs me to do so.

Regards,

Looks much better!

Yes--you fixed the eye openings well. Your ab plate belt looks a bit thick; is it 3 inches tall? Should be 2" like this:

http://s157.photobucket.com/albums/t54/ ... bFar00.jpg

thank you for your input Bonzai88

Looking much better.

The only thing I can see now that will keep you from deployment is your missing the wrist covers. These are easy enough to make out of some scrap ABS and a heat gun.

I did not suit up for this...here are my arms.





hope I make BF deployment!!!!

I'd say you're good to go!

EDIT: Updated your permissions!

I would like to thank everyone that gave me advise with my new build.

Could not have made it without you.

Nice to be part of BF.

Thank you for being patient with your build and accepting of our constructive comments!

Good job on the improvements and welcome aboard!

Mesa Steve